Introduction

Discussion forum for the CAN-FIX protocol. This is a CANBus based communications protocol specifically suited for experimental aviation.

Moderators: John Nicol, birkelbach

Post Reply
birkelbach
Posts: 193
Joined: 04 Sep 2012, 14:42

Introduction

Post by birkelbach »

I thought that I'd write a bit about what CAN-FIX is. CAN-FIX is a CANBus based protocol for the FIX project. FIX (Flight Information eXchange) is a project whose goal is to define or at least document the methods and protocols that different avionics and flight systems use to communicate with one another. Our very own, Vern Little has been maintaining and brokering this information. The details for FIX can be found at http://www.vx-aviation.com/FIX/.

CAN-FIX attempts to create an open standard for sharing data among all the various systems in an aircraft. It is based on the CAN (Controller Area Network) protocol which was designed by Bosch for use primarily in automobiles. It is a multi-node, producer/consumer protocol, which means that each node simply sends (produces) it's information to the network and other nodes simply listen for (or consume) the data that they are interested in. Each frame of information is made up of an 11 bit identification number and between 0 & 8 bytes of data. CAN has a built in arbitration scheme which basically means that frames with lower numbered ID's have priority over frames with larger numbers. The CAN protocol does not make any claims as to what these ID's represent. This is where higher level protocols come in. Enter CAN-FIX.

The 11 bit ID gives us 2048 different frame types. The CAN-FIX specification is really not much more than a description of what each of these ID's represent. Airspeed is one ID and Altitude another. This is not as simple as it sounds because we also have to define the byte ordering, the data type etc. There are other details that need to be worked out (configuration, device identification, etc.) that are also covered.

The specification can be found at http://sourceforge.net/projects/fix-project/files/. It is fairly mature but by no means complete. Feel free to download a copy and come back here with comments. I'd love to get some feedback on the spec.

There is a lot of information on the internet about CAN. It's a neat little protocol and is well suited for use in an aircraft. It's relatively simple to implement (with the right hardware) and should prove to be very robust.

CAN-FIX should make it possible to completely modularize the avionics and electronic systems in an aircraft. It allows for the complete separation between devices that measure, use and/or display data. It should also reduce duplication of measurements in devices that need relatively unrelated information to function. For example, many RV's have creative ways to determine airspeed so that they can adjust the pitch trim motor speed. It'd be easy to read the airspeed from the CAN bus, if the trim controller was equiped. Engine parameter measurement equipment could stay forward of the firewall, static, pitot and AOA plumbing could be reduced to nearly zero and bundles of wires to hand grip switches could be all but be eliminated. If you want to change what the thumb button does just reconfigure the hand grip. Wires are eliminated and integration can be made much simpler.

Take a look and let me know what you think.
Phil Birkelbach
Waller, Texas
RV-7 727WB
www.myrv7.com
Post Reply